Custom enamel pins
The full casting process, from die to carton.
Custom enamel pins →Tooling handled end to end · 5,000 pcs min · 20-minute quotes
Send artworkGuide
Five fittings, what each one is actually for, and how the choice changes with the size and weight of the casting.
A pin is judged twice: once when it is handed over, and once three hours later when it is still on the jacket. The second judgement is entirely about the back.
We fit five types. None of them is universally better; each one solves a different problem.
Butterfly clutch — the standard. Two small metal wings on a spring, pushed onto the post at the back of the pin. Cheap, easy to replace, and fine for anything up to about 30 mm. On a heavy or large pin it lets the pin hang away from the fabric and eventually tilts.
Rubber clutch — the same idea with a rubber back instead of metal wings. Grips the post harder, does not scratch, and holds a slightly heavier pin flatter against the fabric. The trade-off is that the rubber perishes after years of washing and heat.
Safety pin — a closed pin bar on the back. This is the fitting for anything worn by children, handed out at a school gate, or attached to thin fabric or a lanyard where a sharp post is a hazard. It is also the one that survives being put on and taken off repeatedly.
Magnetic back — two magnets, no hole in the fabric. The right answer for uniforms, suits and anything where a puncture is unacceptable. The honest limitation is holding force: a 45 mm pin on a magnet will slide on a lapel.
Keychain fitting — a jump ring and split ring instead of a pin post. The same casting becomes a keychain, which is why keychains and pins share a tooling shop rather than being separate products.
| Situation | Fitting |
|---|---|
| Event pin, 25–32 mm, handed out in bulk | Butterfly clutch |
| Larger or heavier pin, worn all day | Rubber clutch |
| School, children, thin fabric | Safety pin |
| Uniform, suit, no puncture allowed | Magnetic |
| Sold as merchandise, kept on keys | Keychain fitting |
The rule of thumb: the bigger and heavier the casting, the more the fitting matters, and the more likely the cheapest option is the wrong one. A 45 mm pin on a butterfly clutch is a complaint waiting to happen.
Yes. Fittings are fitted at assembly, not cast into the die, so the same pin can ship with different backs within one order — a batch for staff with butterfly clutches and a batch for visitors with safety pins, for example. Say the split in the enquiry and it goes on the packing list.
Only one thing on the back is fixed at tooling: the position of the post. It has to sit where the casting is strong enough to take the load, which is why a fitting is chosen before the die is cut rather than after. If you change from a pin to a magnet later, the casting does not change, but the balance of the piece does.
Tell us the fitting you want per design in the enquiry. If you have no preference, we fit a butterfly clutch as standard and will say so on the quotation, so nothing about the back is a surprise on delivery.
The full casting process, from die to carton.
Custom enamel pins →Minimal line widths and the files that cut a die cleanly.
Guide →Tell us the fitting and get a quote the same day.
Request a quote →Artwork, size, quantity and deadline are all we need. A specialist replies with tooling cost, unit price and a delivery date, usually inside 20 minutes.